Clearview antenna as seen on tv manual#

Here are all the ways the pushbutton is used: In general, a short press goes to the next choice, while the long press selects the present choice. It is important to understand how the pushbutton is used to make changes and see information in the menu system. However the performance of ClearView, even with different antennas, is still far superior to any other video system. If you are racing or doing any other type of short to medium range flying, asymmetrical antenna setups will not be necessary and may work against you. If you are using directional antennas, we suggest that you point them in the same direction. ClearView works with both omni and directional antennas.

However ClearView is not a diversity receiver and does the best noise rejection when both antennas are the same type. Contrary to what you may have heard, you may run ClearView with two different types of antennas on each antenna connector (asymmetrical setup). The supplied power cable has the correct diameter.ĬlearView antenna connectors are standard female SMA. There are some 2.1mm DC power jacks that have a larger center hole, so be careful using other 2.1mm DC plugs. Power the ClearView receiver from a DC source of 3 to 4 LiPo cells using a standard 2.1mm DC power jack (center + ), from any DC source capable of. FatShark does sell a compatible 3 RCA cable. Please note that the FatShark standard does not work with the more common 3.5mm to 3 RCA cables that conform to the camcorder standard. Please consult us if you need a different wiring standard. All units with this later wiring will have an advisory label affixed to the case bottom. Instead, we will supply a 2 meter cable that plugs directly into FatShark goggles and compatible display devices. After 5 seconds, the interfering signal will have usually passed.Īs of AugIftron will no longer ship the popular “camcorder” wiring standard.

ClearView Racing receivers provide better rejection to interference from strong and nearby transmitters on adjacent channels by stubbornly refusing to break lock with your signal for a time period of 5 seconds, regardless of how much of the interfering signal can be seen on your display.

Thus for the best performance, it is important that the camera power connection be solid and reliable. During this time, the receiver will display conventional video. A power interruption (even a short one) at the camera may disrupt this lock and ClearView may take a few seconds to establish a new lock.

ClearView Racing receivers lock onto the camera signal.

This setting can be made by the user (see Changing The Video Format). AUTO is ideal when ClearView is used as a ground station servicing many pilots with unknown video standards. An AUTO mode is available in the user menu that allows ClearView to decide for you. If this setting is improper, ClearView will not lock.

CV needs to know whether the video transmission is formatted as NTSC or PAL.

If in a rare instance, CV can not lock or persistently unlocks, there may be an issue with the camera, transmitter, or power supply and wiring. Instead, ClearView will emulate a high quality diversity receiver. Until this time, there will be no CV OSD over live video.

Getting a CV lock may take a few seconds.

This is your assurance that CV has locked onto the video signal. ClearView (CV) is the only receiver that provides an On Screen Display (OSD) over live video.Here are a few ways in which the receiver operates differently from conventional receivers: The ClearView Racing receiver provides much better video than conventional receivers, even in the most difficult environments. Please check back frequently with the online version for possible changes and updates.

Clearview antenna as seen on tv manual#